This reefbuild is not mine, i just helped a friend build this Saltwater aquarium.
The Tank is ordered with measurement to fit the furniture.
// Recently i have gotten some request for sharing the Arduino code for my homemade camera slider. To start with i just want to say, I'm no master in this, so there can be bugs, and the code is still early and not complete. Recently i haven't had much time for these kind of projects...
Wiring diagram for My camera Slider build. The stepper motors wiring is dependent on witch stepper motor you use, so for that you have to examine how the wire it to the EasyDriver. Also the relay is wired but how you wire it to your camera is also something you have to examine to your...
Make a 3S battery from old Laptop Battery I needed a battery for my gimbal, and wanted to make it as small as possible and still have enough power to run the gimbal properly. The top bar of the gimbal is an old carbon bike handlebar. And I thought it would be cool to have the battery inside...
3D Printing! is it Easy or Hard ? I am about to enter the world of 3D printing because i see the potential in it for my upcoming projects. I have no experience with 3D printing, and I want to see how difficult is it to start with 3D Printing, and does it have to be expensive ? So I found a...
Today i ordered the first parts for my Gimbal project. I have ordered Battery, Motors, and Controller, when i receive the parts i can begin to design the frame. The Gimbal is going the be used with a Sony A6000 Camera. This is the fist gimbal i ever made so this is Not a how to guide(at...
Homemade Concrete table. I was looking for a new coffee table for my living room, because the old one was well used, but i could find one i like, or could afford. So what to do ? Well i decided to build my own and it went quite well i think :) I wanted something with a rustic look, so...